Connecting a plasma cutter to PROMA THC

[@wakedindustrial6368]

Very nice work man!! It's the best instructions I saw! God bless you!

[@AmateurRedneckWorkshop]

What value do you have for the Proma speed setting?

[@tomaberisha5688]

The lowest possible, if i remembet correctly, 2, 0.1 and usually 140 to 160.

[@pascavali4262]

I installed thc sd. It works in tests but in work only raises the head if the voltage is lower. In case of a higher voltage, it does not go down. the lights do not light up anymore.

[@tomaberisha5688]

Never used the SD version, but i think there are settings for steps and speed on the THC.

[@cadcamexpert6070]

Hi sir, I am purchase lotos lts7000 so please help me for hf problum. Moters out of balance and runing high frequency problum.

[@cadcamexpert6070]

1 am purchase 150thc and z slide.

[@algcnc7275]

Hi I was connected the thc proma but I don't know how I use it (button )

[@tomaberisha5688]

Alg Cnc Do you mean how to use the THC buttons? Go to www.proma-elektronika.com and download the manual.

[@mdaftabjan7834]

hi good to improve knowledge

[@algcnc7275]

Thx I have other questions

[@tomaberisha5688]

Alg Cnc , i am still waiting for other questions ! :)

[@macbarrera89]

Hi, I wonder if you could help me. I already set the Proma THC and it works great during the cut, it goes up and down on irregular surfaces. But how can I make the torch to go down until touches the sheet and then go up again to the ideal height 0.100" aprox. at the start of every cut? Did I explain myself? Just to give you more details, I use Mach3 and this type of Breakout Board: www.amazon.com/gp/product/B00SWO2OUU/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1 How can I setup the hardware and the G code in order to get this task done? Thank you very much!

[@bobcoder]

Best to build a floating head setup. Then if you use sheetcam use the correct post processor.