Controlling Festo Servo Drive with Python Library

[@paulgunter9189]

Hello, im trying to run the edcon-gui but its not working. Maybe you can give some short introduction. Thanks a lot!

[@FestoNorthAmerica]

Hi Paul, You can contact our specialists directly using the following link. They will guide you in resolving your issue. www.festo.com/us/en/e/technical-support-id_646900/ Regards.

[@MrKevinbat]

I'm having a problem when xf1 isn't recognizing or responding to python. I have the drive set to mudbus tcp, telegram 111 and configured my ethernet port to work with the ip address I have set for the port.

[@MrKevinbat]

I'm using a cmmt-as-cs-11a-p3-mp-s1

[@FestoNorthAmerica]

It’s important that you Restart the CMMT drive after setting the XF1 port to Modbus. Once this is done, you should get online with the drive once again with Festo Automation Suite and confirm you are in Modbus TCP mode and that the Active network settings are the desired ones (IP address, Subnet, etc.). You can check this under Fieldbus > EtherNet/IP -Modbus > Active. If the problem persists, we suggest you contact Festo Tech Support in your country so they can further assist troubleshooting.