conventional fire alarm system (diagram) fdas

[@rainfordmiller3046]

Great video used a different pen so i can understand the drawing because i want to know if the device used are 24 volts and data

[@PremiertekSolutions]

Great Job.

[@MarioHernandez-wj1iv]

Also would you know how far apart the smokes need to be? Im in California, anything different i need to do due to the place I’m in?

[@kayyatech4580]

Depending on the building's layout. A detector should not be more than 6m from any wall or obstruction, and no more than 12m from another detector.

[@rainfordmiller3046]

Its data and 24 volts system or just 24 volts

[@MarioHernandez-wj1iv]

Where do you put the resistors? Is this similar to most Fire alarms?

[@kayyatech4580]

As the name suggests EOLR should be installed at the end of a security loop. In most cases, EOLR can be only installed at the end. That is because if it's not, the effectiveness of resistor is lost.

[@rainfordmiller3046]

End off the line because there is no return that why he used the resistors. its data in and out or 24 volts in and out if they should add more devices the resistor would taken out and extra wiring to another device and add the resistor to the last one again with an address so the panel could respond to the issue semoke or pull station

[@praveenkonduri1782]

Hi bro. Fire damper connection crh. ct1 divice se 4 damper connection explan plz

[@mychannel8809]

Sounds like a bad connection for a specific device, look at the report it will tell you which device this is and check the wiring

[@BL_Sej]

y u connected supply and backup in series

[@Mrmudbone_gaming]

To get 24v

[@bitrusdenis2373]

Some detectors don't come with the positive and negative terminal names some are numbers, can you tell us how the connections are made with such detectors.

[@mychannel8809]

The detectors that aren’t marked are not polarity sensitive, as long as your negatives and positives line up it will work wired either way

[@roytvvlog9405]

Series lang ba lahat ng sd

[@prakashuthra2221]

EOL value? 10k?

[@kayyatech4580]

It depend on the brand

[@mscreationworks5787]

fire alarm isolator module wiring diagram malayalam

[@mscreationworks5787]

I have worked with a Fire alarm device But I first connected the Wire from panel to MCB than to smoke detector So , Where should I connect the Isolator ? After the MCB Loop to detector or Before MCB Can you tell me the right wiring diagram 1 [ Fire panel = Isolator = MCB = Detector ] 2 [ Fire panel = MCB = Isolator = Detector ]