Copper gaskets must be annealed before using them. Annealing softens the material and must be done before using them to get a proper seal www.ombwarehouse.com/copper-e...
Пікірлер: 19
@fatbuddycat2 жыл бұрын
I needed to see this. Thanks for the lesson Eric!
@PullerbearEd2 жыл бұрын
I also use a nice coat of copper spray coat as a add measure of protection
@jmangus832 жыл бұрын
And quenching in water hasn't no effect on copper/brass like it would with different types of alloys like steel, where it would actually make it harder. All you're really doing is cooling it off more quickly instead of letting it air dry.
@jmangus832 жыл бұрын
You should get some tempilaq and paint it in different places on the gasket, that way as you heat it up, you can ensure it has reached the proper temp
@Moefabco1 Жыл бұрын
Thanks Eric!
@johndeaville9326 Жыл бұрын
Hi - yes have fired up the bbq left the gasket in for 30mins, opened it up and hit it with the torch as well as it still on the bbq, no joy. Also tried the gas ring. Must be just unlucky!. JOHN DEAVILLE.
@daijoubu4529 Жыл бұрын
Arent you holding the touch a bit too close? You would want the tip of the blue flame where it's the hottest
@jaychaney79792 жыл бұрын
Can i use a 4 degree timing key with the omb pvl flywheel?
@abdulsamad_94 Жыл бұрын
Oh now i know why i use copper head gasket with gasket sealer and do a two surface seal , but still leaking radiator water into the combustion chamber .
@AJC-jo3ds2 жыл бұрын
It there a recommended torque spec for tightening exhaust fasteners?
@dharmakissoon10 ай бұрын
Annealing is good but down side its like adding miles on it
@motoridersadventureengineer4 ай бұрын
Can I used annealed copper gasket for crankcase cover?
@emeraldviking36376 ай бұрын
Will it take a bit longer to anneal 2mm
@DIYWilly2 жыл бұрын
What’s the advantage of using copper gaskets? I’ve had no issues using regular gaskets.
@TheGrayGoatGarage2 жыл бұрын
I port match the gasket to the head. I can pull off the header and not have to match another gasket. The foil gaskets tend to pull apart after heat cycles
@garyfry26482 ай бұрын
Cool
@johndeaville9326 Жыл бұрын
So see how long it took to heat that tiny gasket. I have tried to heat a twin cylinder head gasket for a BSA A65 with a MAP torch, I cannot get it to go red. John Deaville.
@TheGrayGoatGarage Жыл бұрын
You need more heat! I would fire up the gas barbecue and see if that will get hot enough. Or try all the burners on the stove when your wife is not home. Gotta get creative!
@mark4lev Жыл бұрын
I’m amazed a map torch can’t heat a gasket to dull red. Washers are easy to do. Takes 5-10 seconds. Maybe gaskets are to thin to heat this way. Incidentally, the best way of cleaning after annealing is with scotch pad.