Good detailing for different weather conditions... beautiful very helpful
@hecra6521 Жыл бұрын
the application is a very hard job and expensive. is it possible to blast the copperpowder on the hull after it is painted with epoxy? i have tried it on a piece of wood painted whit polyester . and it looks good. i mean the copper haftet on the outside and that is the most importent thing.
@rrrrockin12 жыл бұрын
Thanx ,,interesting and informative ,, Im using coppercoat on strutts under a large yacht and for the 4th coat I will have to scuff for a mechanical bond yes ?
@olympicmarine8289 жыл бұрын
Το καλυτερο υφαλοχρωμα (Μουραβια) που εχω χρησιμοποιησει.
@rosewood15 жыл бұрын
When the yacht is supported underneath how long would you wait after applying the first 4 coats to move supports and then paint these remaining bare areas? Thanks for video
@popsoldboats34064 жыл бұрын
I do not see a reply, and would suggest you wait till it has curexdband you have sanded the final coat to activate/expose the copper. Doing this you will only need move your stands one time and fill in and sand the areas wrerebthe stands were. Let me know how it works for you.
@paulgorman80977 жыл бұрын
How much to purchase all the materials for a 29ft Westerly Konsort?
@cadillacescalade18 жыл бұрын
Spraying it will save a lot of time and manpower
@labrat33054 жыл бұрын
Don't believe the pot life or thinning amounts. Get two people minimum to roll out 1 litre as fast as they can. Thin it to the maximum, don't skimp here it will bite you hard. Then it will be ride on. If you listen to their advice about 3 capfuls you will end up with a lumpy pile of shit that will be mostly sanded off.... If they say you need 7 litres, buy 9! You will not get 5 coats only 4 maximum but to be honest I only got 3! See below
@conniefontenot27937 жыл бұрын
Dolphins use to play around our boat until we put this on our boat. J/s
@Austin.Hunt.6 жыл бұрын
You probably have an improperly grounded wire. This coating will be a conductor of electricity