Jeti - throttle trim one step

[@gerrykeaveney1657]

production value much better now Harry ! good move on the 3D printer. Which one have you? im interested in getting one

[@cotswoldpilot]

Dremel 3D40. Expensive but works out of the box, no wasted hours trying to set it up etc

[@alvdany1]

How can be done it but using a 2 position switch? I mean, do the shutdown of the turbine. Thanks

[@cotswoldpilot]

Just use the built in throttle lock

[@johnnyoliveira8378]

How do you have the Servo Setup menu for throttle set? Is there a correlation between both menus?

[@cotswoldpilot]

Servo setup at normal default values

[@cevgemv]

Hi; Just want to ask you a couple of question regarding to the servo throttle: 1) In +82 the carburetor is fully opened an in -92 is fully closed so in order to get my idle speed (DA50) I got it by adjusting the trim button in my radio Jeti DS12. However one of my partner told me that doing this in such way I would be losing resolution of the servo and he told me that it must be done by adjusting the sub trim even when doing this through sub trim you don't lose any servo resolution. Could you give me your opinion and/or suggestion for getting the idle speed ? Best Regards.

[@cotswoldpilot]

I do it the same way use you. Servo subtrim is not a way to do it. Subtrim moves the entire movement of the servo, both endpoints. If you put in +10% subtrim it will add 5% travel so your endpoints would become +87% and -87%.