CR125 Engine Rebuild - Assembly Part 1

[@hazzapatto1994]

Dude your vids make my day you deserve so much more

[@cyrusgooding4860]

I’ve been waiting for this!😂

[@capsitan]

Do you put your cases in the oven before bearing install? I see a lot of people do that and the bearings drop right in.

[@Richiehervig]

Nice video🤙

[@russellafowler7403]

What about the shifter hub retaining bolt ?

[@johnchristie9106]

why dont you heat the casing in an oven bearings in the freezer then bearing should drop into place easily

[@rileywilliams4961]

where can i find a whole kit for my 01 cr125

[@abdulwaliyy1390]

Quick question I have a 2003 cr125 same engine in this video the problem I have is thick oil comes out the top end ware spark plug is plus out the end of the moffler any ideal what's the problem

[@kenweis7913]

Shame you got the wrong year trans bearings.....thats why its important to know what engine/year you have

[@mushmanist]

Where can I find a 02 to 03 cr125 power valve?

[@abdulwaliyy1390]

@AKmoto I have the same 2003 cr125 that u rebuilding in this video. Having problems with thick oil coming out ware spark plug is at plus coming out the end of the pipe. Have any idea what the problem is?

[@akmoto_]

Is there premix coming out of the spark plug’s hole itself? If so, the spark plug isn’t sealing properly, get a new plug and make sure it’s not too loose. A little premix coming out of the end of a pipe is normal for a 2 stroke, especially if it’s running rich or not being ridden very hard.

[@abdulwaliyy1390]

I just bought the bike but it's kinda a lot of thick oil coming from the pipe I have other 2 stokes n never had this problem. I was kinda concerned that oil from my bottom end is coming up

[@Pedro_43]

@Abdul Waliyy, bad crankshaft seals?

[@abdulwaliyy1390]

Thanks Pedro

[@abdulwaliyy1390]

@Pedro Thanks

[@allgood6535]

Vapour blast that before

[@PatrickRiggs33]

Very nicely done 👍. You may have mentioned it in a previous video and I apologise but which press are you using? A harbor freight unit?

[@akmoto_]

In the video I am using a 20 Ton press from Harbor Freight, a 12 ton would have worked too 👍🏼

[@PatrickRiggs33]

@@akmoto_ Much appreciated, thanks👌

[@jackvillegas7765]

What size is that oem bearing?

[@junioryoung1695]

You sound like Tyler monogan

[@jonthelamb4549]

Did I miss a bike tear down video?

[@akmoto_]

No just working on the motor

[@jonthelamb4549]

AKMoto ah ok is it your bike or a customers?