Making a Custom Electric Guitar: 4 - Inlays

If you would like to support the creation of videos such as these, please consider supporting me on patreon: / cranmerguitars
If you are interested in plans, please visit:
www.cranmerguitars.co.uk/plans
Socials:
www.cranmerguitars.co.uk
cranmerguitars
cranmerguitars
"Empty Without You" by DesperateMeasurez
Licensed under Creative Commons: By Attribution 3.0
creativecommons.org/licenses/by/3.0/

[@Ivory_Mist]

Looks great so far! Can't wait until it is all finished.

[@CranmerGuitars]

Glad you like it; not long now!

[@jatna77]

Man, you must have strong arms from all that sanding!

[@CranmerGuitars]

I'm sure I can attribute my strength primarily to all the porridge I've been eating lately! ;)

[@MauriceKindermann]

Are you able to expand a bit more on getting 12-20 compound radius? Did you use multiple sanding blocks, and just get it more or less? How did you determine the frets before seating them? I assume you measured then did each one individually?

[@Allguitarinfo]

I have a question I am replacing the fretboard on a neck that I bought the neck has already been carved .. and the fretboard that I bought is much wider than the neck.. how would I cut the excess off of the fretboard.. if the neck was squared and not carved yet I could run a bandsaw blade down beside it close and then finish it off with a router what would you recommend to get the fretboard the same width??

[@privateforce]

Amazing😍😍👍

[@mgcnashville6615]

Hey man what is that tool youre using to cut the dowel with? Not the chuck. The other one. I've got access to a lathe and a bunch of tools but I can't find it in the boxes of stuff.. I may need to get one. I want to make fret dots using this method as well!

[@deejay7339]

5:36 😳😳😳