thank u bro...very useful and your way of teaching is good...
@CADPLMGuy4 жыл бұрын
Thanks, Bhuvanesh!
@suraj.patil70063 жыл бұрын
Hello, You are doing good job, please keep it up.
@CADPLMGuy3 жыл бұрын
Thank you, I will
@mangeshthakur97434 жыл бұрын
How it knows that how many cables will go through a particular point? How to set it?? Please help?
@CADPLMGuy4 жыл бұрын
You can set the max diameter for a location and that can limit the number of cables through a point.
@mangeshthakur97434 жыл бұрын
I didn't get that. Can you please elaborate it. And this is Part-2B. Is there any part like 2A?
@tomast90344 жыл бұрын
a cable ninja needs only a notepad editor :D (not me)
@CADPLMGuy4 жыл бұрын
I've seen more than one company attempt to skip the schematic and write software to generate a Neutral Wire File. I haven't seen it work, but one day...
@tomast90344 жыл бұрын
@@CADPLMGuy i stopped doing cabling when schematics came in.not by choice, our companz was disolved :D. previously we used pro/diagram in wildfire series. almost the same but different.
@raytheo34733 жыл бұрын
Do you know of any good KZbin channels to help me learn Creo Schematics? I'm an old Pro/Diagram user but have no clue how to even start Creo Schematics. Thank you
@CADPLMGuy3 жыл бұрын
I have a playlist on Creo Schematics. I am not aware of any other videos. I make very few videos on the subject because they don’t get watched.