Creo Parametric - Toroidal Bends | Part Modeling

[@adhithasimhanraghavan7516]

Wow.. this took my design to a whole new level of possibilities 😍. Thanks Dave!! Run for President in the next election 🎉🎉🎉🎉

[@CADPLMGuy]

Glad to hear that!

[@CADDIA]

Thank you and keep uploading

[@CADPLMGuy]

Thanks. Will do.

[@XPERTMINDing]

in 7.0 you also need to select quilt or solid body took to 2 hours to figure out ... i am just learning #beginner

[@CADPLMGuy]

For advanced commands, I recommend reading the Help or watching one of my videos first, rather than wasting two hours.

[@XPERTMINDing]

@@CADPLMGuy I watched this one twice but I was still lacking it hahah Thanks For advice will follow that.

[@mervynlarrier9424]

Can you reference the edge of a surface as the curve for your toroidal bend? Or would you still need to reference it in the internal sketch?

[@sriharikannan6946]

I tried this option but I am not able to get it right... "Geometry rotatable coordinate system is missing" comment comes

[@wendelcardoso9033]

Goodnight! So I wanted to have a question, does the toroidal option only work on a solid basis? could you explain how to use the option "keep flat and expand"?

[@ash_deol]

Nice

[@CADPLMGuy]

Thanks, Ashish!