crown RC3000 rail cylinder reseal job

This video is how i replaced the lift cylinder seals in a old Crown RC 3000 Electric forklift.

[@kevinmoore7635]

You have inspired me. I wanna be a forklift tech. Just like you

[@jeremysturgill8426]

First step: leave your current place of employment 😂

[@kevinmoore7635]

@@jeremysturgill8426 ha I did that back in January.

[@c.n.9074]

Shouldn't be a problem... for tools you will need a big hammer, a bigger chisel, some paper towels for cleaning and some rubber gloves.

[@pwilliams2537]

I have a question what type of hydraulic oil do you use to full the reservoir

[@billbrady6514]

I have a question for you. What would you recommend I use to clean and degrease the chains? I’ve used a few chemicals from dobmeir but nothing seems to clean them enough so I can re-lube them.

[@jeremysturgill8426]

Brake clean will clean off most all the old grease and gunk from the chains.

[@billbrady6514]

Do you have any short cuts like this to replace the column rollers without taking off the entire mast? I have a crown tc-3020-30. Same setup your using in this video

[@jeremysturgill8426]

Hey sorry for the delay. Yt is not notifying me of messages on my videos. If you are referring to the mast rollers, there is no way to replace them without mast disassembly.

[@Roosters-rants1977]

Those cylinders are a bitch to get all the way out. I just remove the ram