RadioMaster ELRS UART Flasher - how to flash and/or recovery from a bad flash

[@MCsCreations]

Awesome review, Wayne! Thanks! 😃 Looking forward to the review of the receiver! Stay safe there with your family! 🖖😊

[@CurryKitten]

Cheers MC

[@EnglishTurbines]

This is why Im sticking to Crossfire...The TX Module uploads matching Firmware to its recievers OTA. Dont have any of this nonesense and you can upgrade RXs installed in models easily...No PC involved...😳😳😏

[@CurryKitten]

My Crossfire Module managed to screw itself with an update one time... although to be fair, that was because I had to use a Windows VM to update it, and it has a Mac version now. It was recoverable though.

[@EnglishTurbines]

@@CurryKitten I'm not sure why ELRS doesn't do OTA firmware updates. After all they've copied the protocol from Crossfire....🤔😳

[@qck57594]

@@EnglishTurbines Elrs does OTA updates

[@EnglishTurbines]

Obviously you need pin holes in your RX PCB for this kit to work. So well done RM once again providing a half baked solution....Im not sure why they fail to see the blindingly obvious Wayne...?...😳😳🤔🇬🇧 Saving money by not drilling the PCBs

[@MrZeek101]

Hi would you be able to flash r9mm to elrs using this without using betaflight passthrough mode

[@housinit]

Pull power from the receiver when the configurator says wait for the LED to continue blinking, thats when its actually writing to the chip.

[@CurryKitten]

Ah - ok, so it copies to some memory during the "flashing" from the configurators point of view and then does the actual copy into flash ram afterwards. Thanks - noted for future

[@fly249g]

Nice