Custom Rod Building - How to Apply ABALONE VENEER - Heat Gun Method

[@Glennmc7]

Nice work and very good instructions on Abalone Veneer, What brand of Veneer is this and how can I buy it.

[@sebbosaurus]

Very informative, I'm wondering could the inlay as well as a coat of finish could serve as the under wrap in place of a tradition thread based under wrap? Thank you, I'm always learning from your videos

[@reelbluecustomrods]

Yes it can, and thank you for watching and commenting.

[@ETuss713]

Found the video! Thanks for the info. I got my abalone from Mudhole. Not great looking. Any sourcing recommendations?

[@reelbluecustomrods]

Which one did you order from them?

[@travisthompson3700]

I guess you like Heatgun vs. soaking it in hot water? Tips on not getting cracks?

[@reelbluecustomrods]

There is different types of abalone veneer. Some you use a heat gun, which I find easier, and then others you have to soak. Thank you for watching and commenting.

[@travisthompson3700]

Did/do you any cracking issues and any tips on dealing with the seam (looks)?

[@reelbluecustomrods]

@@travisthompson3700 - yes, cracking issues with the water technique, so that is why I prefer the heat gun type of abalone.

[@hooksetstronghooksetstrong7091]

Can you use a hair dryer instead of a heat gun

[@reelbluecustomrods]

You could, but it may take a little longer to warm up. I would use a heat gun if you can get one though. Hope this helps, and thank you for watching.

[@forrestpeters8142]

If you run a cover thread and you will lose your seam

[@reelbluecustomrods]

Thank you for watching and commenting Forrest.