Very nice work Sir. Really enjoyed your show and explanation too.
@charleskutrufis961210 ай бұрын
Enjoyed this very much, Thank You
@kappullen4 жыл бұрын
I extended an arbor press ram an inch or so like this on my G & E shaper to get a bit more stroke. It was actually a harbor freight gear/rack arbor press. I was making a slotting bar to cut some Cylinder liners out. I pressed is a square hole bushing For a slitting cutter. Worked fine. Good Video. K
@johnstrange67995 жыл бұрын
Sweet! I like seeing parts for other machines being machined.
@hilltopmachineworks21314 жыл бұрын
Enjoyed. My 16" G&E is manual down feed also so I know his arm was tired. :) Are those way wipers factory or did you make them?
@heavymachining78304 жыл бұрын
The wipers I made myself from one layer of felt and one layer of leather. And yes it is a good amount of exercise for the arms!
@stevenbodum34054 жыл бұрын
i cut with the block automatic feed up
@roncoath3 жыл бұрын
why has the vertical slide been set over, does the mean the tool will cut more on one side than the other. Is it like setting over the topslide on a lathe to cut threads. Ron