Cutting Segments for Bowl Using Vectric and CNC

[@joeycast]

Great video! Did you post the calculation slide as a PDF someplace? Thanks for the lesson. :)

[@WorkAgainstTheGrain]

I ran the spindle at 16000 and fed the machine at 1500mm per minute. Thank you for watching.

[@sadufkafhjv]

Good one, what are you feed rates and rpm?

[@chuckbriggs3031]

I was wondering if anyone has tried this! Problem is I can cut them on my segment sled for my table saw so much faster and just as accurate! Good video though!!

[@WorkAgainstTheGrain]

I did it as shown in video and it REALLY came out clean. To your point however, my wedgie sled on my table does in fact do it faster. Thanks for watching

[@cliffyboy76]

I was thinking the same thing. I'm planning on remaking my segment sled with my CNC to make it more accurate. The table saw will make a set of wedges in about 1 minute. I was thinking of trying this though, as the wedges would be extremely precise from the CNC.