Cylinder head surfacing you can do at home!

Just showing everyone how we prep our head and block surfaces on our junkyard builds.

[@chriscampbell5624]

nice work! I'm going to give this a try!

[@electrochubb]

Looks effective, maybe do a light valve lapp with ultra fine compound.? I've know people to use corn starch.

[@cheeseandpickles98]

I used tooth paste once and it worked

[@dominicallen2953]

Man thanks that will do the trick 💪🏾😂

[@cheeseandpickles98]

The MLS gaskets are sensitive to RA surface roughness over time the expansion and contraction. Or cylinder head lift under high pressure(boost) will eventually cause the gasket to fail I reccomend if you do this use the earlier paper/graphite ls head gaskets in a non turbo application

[@vrm86gt]

Wayne, how smooth should the block surface be? Ihaven't run MLS gaskets before but have some Cometics on order, my block was decked about 6 months ago at the machine shop so it is in good shape just don't know if there are additional steps to take before running MLS gaskets. Thanks!

[@koollee]

Great but u need to clean all the grit out right

[@anthonyrybczynski5420]

koollee yeah, the same happens when you machine it. You always have to clean it unless you are a hack or you are building a competitor's engine. Time and detail is everything.

[@esteemedenergy]

125 to surface a head! Your local shops belong to the cartel?

[@franklinhicks]

GetoverYourself 150 eveeywhere i am

[@keyg3n_]

its 250-400 here, i might as well get a new head entirely if this doesnt work hahaha