Reading a Porsche Rear BCM using VVDI PROG

This is part 3 of a series aiming to compare the vvdi prog, cg pro and autel xp 400 pro programmers. In this video we are attempting to read a rear BCM for a 2015 Porsche Cayenne.
Part 1
• XP 400 PRO VS CG PRO V...
Part 2
• Reading a Porsche Rear...
+++Our Facebook Page+++
/ dallasautodiag
**Our website**
dallasautodiag.com/
Thanks For Watching!

[@lowridermig]

Thank you for taking the time to share this with us.

[@DallasAutoDiag]

My pleasure!

[@DTEAuto]

Thank you for sharing these videos. I definitely wasn't expecting a no read with all the programmers. looking forward to the next part for sure. P.s. side note, I have been able to read "locked" bcm2's with the autel on the Audi and Porsche side, so definitely surprised with all your results so far. Hope all is good and keep em coming! 👍

[@DallasAutoDiag]

I was surprised myself also lol. maybe a different mask number has a better resaults than the one I am on. I do have a sucessful read on another one for a 2018 Porsche Mccan front BCM.

[@nickayivor8432]

Can't wait for the next video, Dallas Auto Diag 👍 QUICK-WITTED, Dallas Auto Diag Enjoy your weekend with all your family around you, Dallas Auto Diag From Nick Ayivor from London England UK 🇬🇧 ⏰️ 14:57 Good Afternoon

[@DallasAutoDiag]

Thanks 👍

[@HardwareTX]

Lift the power pins off the board, old cas 3 9s12 reader should read secured 9s12 chips.

[@DallasAutoDiag]

could you share a link to which one you mean? I tried googling it but the resaults got me confused. Thanks

[@oliverpopov985]

Hello, probably sound stupid but did you try with autel to use diagram from vvdi and cgi, with vvdi to use from autel and cgi...... you get the picture. Any way...... I'm just a beginner and i really enjoy your content. Take care

[@DallasAutoDiag]

its not stupid. Im not sure if you watched the previous parts. I did mention that I want to do that. I haven't done it yet. I had so little time as the customer want the module to be programmed asap. I still have the bad module so one day I will try that.

[@kjm1988]

Probably you don't have enough power, lift vcc pin or power on board, or power only voltage regulator on the board.

[@DallasAutoDiag]

I got to keep the donor mcu. I'm gonna try to read off board to see whether it's a tool or setup issue

[@kjm1988]

@@DallasAutoDiag don't forget quartz oscilator if you working off board.