I just had a BCM connector wet tinting a windshield, and it scared the S$%T out of me since the car went crazy, wipers, lights and did not start, fortunately I know electronics, immediately removed power, pulled out the module, cleaned and dried the pcb and connector, and all was fixed, I got lucky no damage occurred on the pcb of the module, I did not use neither the soak rope or towel, this wont happen to me again, thank you sir! your channel is amazing!
@FadeToBlackLLC4 жыл бұрын
I need one of those custom Flex Towels. I've been using both but I never thought of using the towel to trap the solution. Your right though, pulling that rope out it is does drip because it's full and can't hold any more fluid. Good video 👍🏾
@jeffreyg57183 жыл бұрын
Stay Faded, Wayne!
@FadeToBlackLLC3 жыл бұрын
@@jeffreyg5718 I'm trying, thank you.
@Tundra4554 жыл бұрын
Loving my new tint @Ralph.
@juanflores73944 жыл бұрын
I used the towel that I have first and for second measure I used the soaq rope and when I pull the soak rope I am sure that if water drains back the towel will catch it and I have seen the effect on the towel ur talking about and for leather dash I put several water absorbent towels on the bottom just for safety precaution it makes me feel a lot better