DC-DC 400W 15A module Step-up Boost Converter + poe injector

[@24cata24]

i used it to charge a 36v lithion battery, so at 42v and 2 Ampere out , i was using 18v and 6 amps on input. Problems begin if you set the boost converter to charge with more amps 3-4 for example at 42v ..it will draw like 8-10 amps out of the power supply, and if the power supply cant take it it will drop voltage under 8v and go maximum amps..the the buck coverter will spike at 100v. is a good converter but be carefull so the power supply doesnt go below 8v. I recomend a PC psu as it has lots o power

[@RohanChowdhury-jv1iq]

Can i use 5 volt in input

[@LeopoldoFernandez-o9k]

You put digital Voltage indicator only. Better if dual ammeter+voltage reader.

[@LeopoldoFernandez-o9k]

They say the voltage comes out was spiky. Or not clean dc

[@MsAxelfoly]

I added this to the psu, the psu turned off for battery charging. 14.4v 8a needed for battery , why did this happen

[@juanjoseperalta5188]

QUE MODELO ES EL MODULO STEP UP

[@vengug7303]

Hi which ic used for this controller

[@nerzaelectronics7474]

uc3843a and strs204sct

[@Paul_Poanie]

Kannst du auch schpreschen???

[@minjejjel9646]

Ambil inputnya dari psu trafo rakitan bisa itu ya gan?.. Dan apakah tetap setabil?

[@technicaldroid4567]

Itne zyada voltages?

[@ronalduy8022]

Pwede poba jan 5 volts input at 12 volts output?

[@mehmetyuksel9465]

no min 8 v

[@MrJoaquinnavarro]

kahit ilang ampere yung 12v adapter kkayanin?

[@CuongNguyen-xv2cm]

Whats value of Potentiometers

[@zaenalabidin395]

automatic cut off ?

[@biomedicalelectronicsengin7192]

Good

[@nerzaelectronics7474]

thank you

[@rohtashsingh1222]

@@nerzaelectronics7474 भाई कोई ऐसा बुस्ट कनवर्टर है जो एम्पेयर भी बढाये

[@darkprinz2672]

gagana na ang 48v poe comfast access point?

[@mikelramilo1954]

Sir tanong ko lna kung hindi ba maaapektuhan Yong comfast pag sinet sa 50 plus ung voltage ng converter?

[@nerzaelectronics7474]

hindi naman po kasi sa loob ng poe injector may regulator pa po yan..

[@mikelramilo1954]

@@nerzaelectronics7474 salamat sa sagot sir..

[@clentnicasio]

Sir is it advisable po ba? Meron kasi akong 12v 400w in 30m run sa load pero nag drop to 8v.. Thinking ko po kung pwd to gamitin to boost the end before load

[@Zain.Shikari]

Dragging video

[@harimulyana112]

ini video maksudnya apa ?

[@monglumia1509]

Halo

[@miorieser3210]

??

[@Gust4247]

a nao vei vsfd o cara soldando o fio ao inves de colocar nos bornes

[@romeroblog4395]

Hindi maintindihan