DC Motor direction controller circuit | DC Motor Forward -Reverse control using Relay and pushbutton

[@JM_Tushe]

Pretty dang easy to understand, thank you! 🙏

[@mixme8655]

New subscriber always watching your videos❤❤😊😊

[@AztecWarrior69_69]

You shouldn't have the current to the motor running through the switches. Better to use two SPDT relays.

[@suprabapak9129]

what apk did you use for that simulation

[@tryitnow4928]

falstad

[@AztecWarrior69_69]

@@tryitnow4928 NOT

[@ggd5899]

could you please suggest relay

[@AztecWarrior69_69]

Relay depends on Load.

[@lsspfrdcenter2552]

Hi if the on-off switchs are replaced by limit switches , then the above operation continue forever till the battery out??

[@AztecWarrior69_69]

No. If you need this I have diagrams.

[@sureyyaak5215]

Dear sir, as you know sw2 button does not affect. Because relay NC contact already connect cables to the motor for one direction. And when you push sw1 button relay activates and connect NO contacts . Because of reverse cable connections motor turns oppsite directions. Another bad design of this circuit you should push the sw1 button for continuously for continuous turns. Because relay not lock itself when you push sw1 button. Best wishes.

[@circuitspedia]

Thanks for your suggestion 🙏