delmarva testing 62020

[@paine1985]

Love it. Thanks 😊 for sharing

[@camaroboy383]

Love to see it hit the water brother! Be careful with that needle my friend.. For sure get that motor higher.. try center of the bullet 1/8" higher than the rear inner edge of the sponsons.. your original needle setting was probably pretty close to where you need to be for right now.. Definitely get rid of that 440.. I wouldn't bother to much with props unless it's a x637 or a reduced x640 to 38mm.. think I sent you some sholund props? I can't remember.. I know they are much more finicky than gassers.. but stick with it, when it steps up on the pipe you and the tt should be quite happy...😎

[@okiedoak201]

Hello Alden... Well after that run ... I got home and took everything apart...and found the exhaust header was mostly blocked due to an over zealous owner and a tube of silicone... The exhaust header seal was not the correct item and I attempted to make it seal with some silicone.... Fathers day I restarted the engine and there is noticeable power increase...i can't wait to get to the pond and retest.... definitely use a different prop...

[@okiedoak201]

Alden... I had the props you sent to me..but with the rain I did not have a chance to try them out on this session..

[@strexttp]

Super 👍

[@hubertwarf2500]

I like it.wally.

[@okiedoak201]

Hello everyone...when I got the boat home I removed the tuned pipe and found I put some sealant around the silicone coupler and it blocked the exhaust flow...cleaned it out and got the correct coupler for the engine/header..much better results

[@bermyvlogger]

i like to see scratch build. 1 too many blades on the tunnel. save that prop for mono . also prop nut too big

[@okiedoak201]

I had a guy want that boat so bad...so I sold it to him...he put a O.S. outboard on it and loves it..thanks for the input...im onto gas and currently build the new Zippkits outboard...

[@bdanielcal4608]

A 440 3 blade prop is a great prop for that boat I won 14 races in namba in tunnel with it the cooper pipe is a great pipe also as for the nut it's definitely not a prop nut