Designing and Building a Sailing Canoe - Part 1

[@rudywoodcraft9553]

Hi Lee on a whim I watched my old video about designing and building my sailing kayak Nomad and realized I hadn't checked out your video from your comment. Very similar indeed! Well done!

[@iamarat]

what scarf joint did you use at 1:00

[@leemelbourne3297]

I just planed down two angles until they matched up nicely and had a reasonable amount of overlap.

[@fredjensen1683]

what thickness plywood, was it marine grade?

[@leemelbourne3297]

4mm. Yes, marine grade.

[@julianowelter3178]

opa consegue me passar as medidas tenho interesse em fazer um assim pra mim

[@leemelbourne3297]

As you can see at 1:30 the lengths were all worked out by just testing. The width I determined from a kayak I have, and is about 70 cm at the waterline and I think about 85 at the gunwales. I tested to make sure I could still paddle given the width. I need to make another video, as i have modified it substantially since then. I am building some outriggers as I sail on a bay that gets quite choppy. The narrow width is not suitable for sailing in large waves.

[@OuiOui-pb8by]

Interesting but the music is unbearable