DeWalt D28402 angle grinder not working: Diagnostics.

[@joseph-ine452]

Outstanding. Great work there troubleshooting dewalt grinder

[@ArcanePath360]

Nice, to the point useful diagnostic testing method. Thanks Am I to assume that if I have continuity to the brushes, it's definitely the brushes? The shaft spins freely by hand but my brushes also look like they have plenty of life. When I removed the shaft the brushes pushed in about a cm on both sides.

[@lunchboxproductions1183]

There's a possibility that it could be the armature but brushes are so cheap it's worth getting a set to throw in and try out. Do the brush springs have decent tension and do the brushes move freely in their holders?

[@ArcanePath360]

@@lunchboxproductions1183 Hi, it turned out to be a dodgy power cable in the end. Now fixed, thanks

[@esfrincortinas3870]

great video and good info, thanks

[@lunchboxproductions1183]

You're welcome! I'm glad you found it helpful

[@pablogonzales3704]

Nice diacritics man!!! did same dial I dint have continually, on the cord or the switch, I got bad brushes I have no idea 🤷🏻‍♂️ where to get some any ideas 💡?? Thanks

[@asztapaszta9]

Nice video, thank you!

[@lunchboxproductions1183]

You're welcome! I hope it helped out

[@pfuisi]

Hey, I just replaced the carbon brushes and cleaned the commutator on my angle grinders - I made a video too. CU

[@travisspinks5354]

Nice work great vid thank you!

[@lunchboxproductions1183]

You're welcome! Glad I could help

[@TheRealCozy]

Damn man you don’t even have one car video

[@aamilhussein5300]

Good 👍

[@Good-Enuff-Garage]

I just check the brushes first, no need for specialty tools

[@askalmon4174]

Possible not working because of carbor brush?

[@kanagukanagu1616]

Coeil pogalaina Enna poraplam brain. Akum

[@wyomingguy4743]

Pk