Direct hot water cylinder install in 8min

[@ELCR777]

outstanding 👍

[@1stevew]

Another cracking vid..... !!! How do you get those swages looking soooo good??? ...... I keep trying ,but mine just End up so baggy I'm frightened to actually even solder it as I fear it will g leak ....it doesn't feel like a tight fit so end up using an end feed coupling!! Thanks again

[@Sefolli_Klodjan]

That’s very strange?! What brand are your ones!

[@1stevew]

@Sefolli_Klodjan its the spin swage.... 15mm

[@Sefolli_Klodjan]

@1stevew ok I think you just need to speed up the swagger timing. How long does it take you to make a socket normally?

[@1stevew]

@Sefolli_Klodjan hummm I think about 20sec ... I guess I could just try pushing the bit harder and faster into the pipe... I think you may be right !! Pipe is getting too hot and any slight movement with the drill is causing it to go into a baggy socket...

[@Sefolli_Klodjan]

20 is way too long time and the socket gets bigger and thinner walls to do the joint probably 5-7 seconds and push till before touching the end of the tool to avoid overlap