DIRECTIONAL OVER CURRENT RELAY WORKING PRINCIPLE|DIRECTIONAL RELAY SETTING|PROTECTION

[@christopherserojano3953]

Thank you Sir, I have watched other discussion on the same topic, but yours is the most comprehensive and intuitive. Very good lecture!

[@NiteshKumarElectrical]

Wonderful explanation ! You covered point wise concept very clearly !! Kudos to you. Keep on clearing doubts like this. This is just like helping tech young minds and doing free of cost service. As I agree that sharing knowledge must not be restrained by any means. Finally, Thanks !!💐

[@NoHeartAnthony]

Many thanks for your explanation, from a trainee commissioning engineer in UK

[@prabhakarangovindaraj9238]

Thank you so much sir much waiting for this video only 😂👍👏

[@enriqueh8847]

Thank very much for this part 2👍👍👍

[@rameshtripathy5978]

Thank you so much Sir for your Beautiful description and it is very much helpful !

[@harshitmishra2308]

Great great great knowledge shared sir

[@jollysingh3949]

Amazing, thank you!

[@Cromanea]

Great 👍👏

[@tjjanarthananx]

Is there any difference operating region change. For RCA -45 ° and MTA -45°.. please explain sir..

[@enriqueh8847]

Is it possible to do one example numerical calculation? Thank you very much.

[@mijoizagas3747]

Well done !!!

[@nathans5529]

Reverse power relay and directional current relay both are same or some different?

[@rasersk1691]

Sin to cos conversion at 5:28 is wrong, ig. Could you please explain, maybe my math is wrong. Dunno.

[@VinodPrajapati-sb4ho]

Sir please explain this Schneider micom relay P122,P222 etc

[@md.shahjahanali4285]

I cant understand why the angle is theta-phi. I think it would be theta+phi. Please explain?

[@anilshemade6048]

In numerical relay in which context the MTA/RCA is used?..MTA is applicable in EM relays...will you plz explain?

[@vipulkamdar7834]

Good explanation sir. But why the EF direction is minus in its setting?

[@jorgeamado9539]

Please can you explain how should we configurated the characteristic angle for numerical relays

[@GauravGupta-pb8mk]

Thank you sir

[@yuvvraaj4590]

Please can you explain how to size EDG in oil & gas industry

[@electricaltechnologyandind5335]

I understand edg stands for emergency dg....

[@yuvvraaj4590]

Yes

[@Mtenesac]

Why the angle between the vref and the flux v is not 90 degrees, i have seen many text that stated that, by the way thank you very much for the content i am studying this at my university and i am a little bit struggling haha

[@shihabahmed1457]

Thanks

[@md.shekhfarid6424]

Super

[@abtech2478]

sir your blog is not updated. Its better if there will be some notes on each lecture. Also how, much is approximate earning from the Blogspot?

[@satya7077]

Good explanation sir.... Please tell how the principle applied in microprocessor based Modern relays... Waiting for a New video...

[@rimonalhelal3630]

❤🇧🇩

[@velusamypothiraj2300]

You have define with examples

[@electricaltechnologyandind5335]

In my next video i will explain how exactly the direction is measured...

[@do_not_reply4784]

maha vahiyaaaat explanation

[@MrAshwanisaini]

Thank you sir