Beautiful explanation and great job 👏👍appreciate it and hello from Denmark 🇩🇰
@Texas_taildraggin2 жыл бұрын
Thank you for transferring your knowledge to us!!! Very grateful
@edstransitscott91866 жыл бұрын
Great. Information
@g503presidentjr.36 жыл бұрын
Great video from jake grenier
@charlespayne10616 жыл бұрын
Great video could a 3 in 1 ball joint press work to put in new needle bearings
@Verduk4 жыл бұрын
muchas gracias , saludos desde chile.
@martybrooks55934 жыл бұрын
hey Scott, what torque setting do you recommend on the castle nut of the ball joints when fitting? Those ones you removed in the video seemed to be just hand tightened. I don't see any mention in the TM but would appreciate your advice on this - thank you
@TeamG5034 жыл бұрын
Marty, I tightened the new ones tight with a wrench and then backed off enough to allow the cotter pin hole to line up👍
@martybrooks55934 жыл бұрын
@@TeamG503 Thanks Scott - I really appreciate you taking the time to reply 👍
@darkserra16 жыл бұрын
Scott, are you going to do more videos? Love the series, I'm following along tearing down my 1943 GPW
@TeamG5036 жыл бұрын
Jeff Morris absolutely. Look for a new one next week.
@robertnotman3106 жыл бұрын
Penetrating catalyst? What did you use? Thanks, Great video.
@TeamG5036 жыл бұрын
Robert Notman PB Blaster Or Kroil are my favorites.
@nomex19965 жыл бұрын
50/50 ATF and Paint Thinner in a Spray Bottle. Works great and is very inexpensive.
@degerton25 жыл бұрын
How do I know when I should replace the Bell Crank Shaft ?
@TeamG5035 жыл бұрын
David Replace whenever you see grooves on the pin from the bushings or bearings. Visual inspection from turning the wheel you can see movement. Early bushings were replaced with bearings. Those can be wore or damaged before the pin.
@stijn5016 жыл бұрын
i wish i had these vids a few months ago :p
@philipbugher892 жыл бұрын
Do you have videos of m38a1?
@nomex19965 жыл бұрын
Penetrating Catalyst 50/50 ATF and Paint Thinner in a Spray Bottle. Apply liberally!
@johngibbins5587 Жыл бұрын
From 9 minutes on if things don't work out so easily as is often the case, here is how it can be done: www.jeepdraw.com/images/HOW-TO-R&R-Bell-Crank-1-APR-15.pdf