I have to Thank you, my brother has a 2003 Chrysler Sebring coup. It's the same engine as a Mitsubishi Eclipse so we were able to change the starter using your video. So we Thank you
@BoDiggety15 жыл бұрын
thanks for the help guys, in the book it says in 4 cylinder older than 2000 you have to remove the heat shield, we have a 6 cylinder but it looks like there's a heat shield there too it's really in the way and i can barely do anything with it there. Is there a reason i shouldn't take out the heat shield as well? is it attached to something i don't know about that would mess something up?
@VetealaChingada7 жыл бұрын
BoDiggety Take off the heat shield
@AntiMusick13 жыл бұрын
@60magras i removed the cover but the real problem was the contacts on the battery poles needed some find grit sand paper cleaning.
@Dethsing11 жыл бұрын
you have to wiggle it out. basically its all from the bottom. I have headers on mine so its a little easier for me but all you do is disconnect the negative battery terminal then remove the heat shield form the starter then unbolt the starter then slide it away from the engine, To drop it out of the car I had to lift it up higher and around my headers and then back down. I did not have to remove anything else except the heat shield. You should have a decent view of it from under the car.
@Beacon34214 жыл бұрын
I am changing a starter on a 2001 Eclipse 6 cyl. It took me 45 minutes to get it out after I had unbolted everything. I haven't been able to get the new one in yet. The engineers designed it purposely to make it difficult for me individually I'm sure. But I'm going to outsmart them.
@1989rrichard13 жыл бұрын
verry informative thanks man...
@BigBad198911 жыл бұрын
Can you do this without any access to the under side of the car? I don't have any tools to lift my car.
@Dethsing12 жыл бұрын
@dharma760 yes you can ive done it about 3 times, its not that hard work wise, but the cramped space makes it difficult if u need help message me and ill help you out
@chloethoma6012 жыл бұрын
how do you pull the starter out of the v6? i tried pulling the oil filter that didnt work.. any advice?
@madmartigan680111 жыл бұрын
how did you get it out I have 6cyl and it I can't see how to get it out either
@miajjay12 жыл бұрын
I've done everything on the video and I still can't get the starter out. It seems to be rusted on or something. I can't get a good grip to pull or an angle to bang it loose. Any suggestions beside WD-40?
@VetealaChingada7 жыл бұрын
Jay Ortiz Use PB Blaster™
@billstickly115 жыл бұрын
thanks man
@QuantumBunnii12 жыл бұрын
Does anyone know the torque specifications for the bolts on this thing?
@dharma76013 жыл бұрын
can you do this on a 6cyl?
@AntiMusick13 жыл бұрын
i just did this today and the thing still will not start.