Рет қаралды 6,302
#HpiBaja #18650 #Batterypack
Replacing the old Nimh battery pack with a DIY 2s 18650 2500mah Battery Pack for my HPI Baja 5b 2.0.
The 5 cell Nimh receiver pack was unable to charge fully and couldn't sustain power for more than a few minutes.
If using nickel strips then use a battery spot welder otherwise use silicone wires.
Its easy to burn the cell shielding while soldering so take precaution to avoid
damaging the cell.
Soldering the cell terminals can be tricky so use a good clean soldering iron and avoid heating the cells.
If you have more room in the battery bay of your rc model then use foam cushion and heat shrink to add some protection to the battery.
The 2s Li-ion Pack can be made using a battery protection circuit (BPC) or using a 2s JST Balance wire, I decided to use BPC to avoid using balance connector during charging.
Thanks for watching!
Subscribe for more videos.
Music - KZbin Audio Library