DIY Clutch Centre Holding tool and tips to remove that STUCK clutch nut

[@owenbowman9275]

I just used a flathead screw driver for a wedge between the plate and an impact. Mine was not even close to that tight. Glad your tool worked!

[@dtaylo4517]

Impact gun for sure they have no troubles, but I haven't a compressor and I like making tools :)

[@owenbowman9275]

@@dtaylo4517 I just use ryobi tools, they make a nice small impact and 1/2“ for the future. Your tools are great though!

[@davidrsmith2417]

An impact wrench is the best way. 3 types: hammer blow tool (old school), air tool, electric tool. These of course can be used for dozens of other uses (tire removal, ball joint bolts, etc).

[@dtaylo4517]

Your absolutely right! but I dont own a elecy tool or an air tool/compressor. Plenty of hammers though.

[@maxgood4361]

Jeez, what’s the torque rating on that nut. That was unbelievably hard on my knuckles just watching. Neat tool to keep around. Thanks for the post.

[@dtaylo4517]

127Nm It put up a good fight

[@richardlinsey2419]

That nut seems way to tight, At least the tool worked bud (with a little 💪) nice one. 👍👍👍

[@dtaylo4517]

30ish year old bike and its probably never been off.

[@bhoktongchannel9334]

awesome👍

[@dtaylo4517]

Thank you! Cheers!

[@Crosshatch1212]

Heat REALY is the secret ingredient

[@Crosshatch1212]

It would be easier to by the tool ,🎉😂

[@Outdoorjunkie246]

zip it off with a impact gun. problem solved.

[@dtaylo4517]

And...if you don't have an impact gun?