DIY - CNC ENCLOSURE // USING LEFTOVER WOOD ONLY

In this video I built a CNC router enclosure, using only leftover wood around my shop. This machine (3018 PRO) can get really loud when it's cutting, so i had to come up with an idea to make sure the noise level is as low as possible. I added soundproof foam tape where the door is closing and extra layer of Silicone in the joints all around.
Adding acrylic glass to 2 of the sides allows me to regularly check and monitor the cut.
Featured products:
- Acrylic plexiglass (pack of 2) 42 x 29 cm (Currently out of stock on Amazon, but there are many similar items
www.amazon.co.uk/gp/product/B...
- 2M LED Backlight USB
www.amazon.co.uk/gp/product/B...
- 10mm Soundproof foam isolation tape
www.amazon.co.uk/gp/product/B...
- Spring loaded toggle latches (pack of 2)
www.amazon.co.uk/gp/product/B...
- Ball bearing runners (for the laptop shelf)
www.amazon.co.uk/gp/product/B...
The rest of this project is leftover 18mm Plywood, 18mm MDF and 12mm Plywood for the additional shelf underneath the enclosure.
Social media:
Facebook: / minimal.momento
Instagram: / minimal.momento

[@gianpietrovairo3557]

a beautiful project!

[@MinimalMomento]

Thank you very much

[@RoboArc]

Should put foam in it.

[@endoortv]

Kan je zoeen frees 3018 hebben als je in een flat woont of is dat niet te doen?

[@MinimalMomento]

You can definitely have this cnc machine in a flat. Just make sure to soundproof it well, so your neighbours will not get angry about it, as it can get very loud without it.

[@endoortv]

@@MinimalMomento thanks for the reply!👍🏼

[@funnypetsnation3601]

Waste of time, i was hoping you would show the machine on to listen to the sound

[@MinimalMomento]

Thank you for the comment. This video was focused on the built of the enclosure and the difference of the noise levels with and without the enclosure, rather than showing the machine itself and how it functions. Sorry to hear that wasn't useful, but even the title mentioned what was the content about.