DIY CNC Milling Machine Build - (Part 8) - Z Axis Carriage

[@Mrxman94]

This is the best diy cnc series i have seen on yuotute. Keep up the great work.

[@SeabassEngineering]

Thanks for the comment, will do!

[@GBWM_CNC]

Nice work. Looking forward to see some flying chips on this machine.

[@SeabassEngineering]

Thanks for the comment. Me too!

[@fidarehman2641]

@@SeabassEngineering a

[@rcalin9354]

Nice work. Good job!

[@SeabassEngineering]

Thanks for watching

[@rcalin9354]

@@SeabassEngineering you're welcome. I am building something close to your build, but pretty slowly, i dont have too much time for it.

[@cncmetalworks]

I would suggest looking at moving your power / component board - if it's going to be at the base of your machine the first coolant leaks might get into that box - look at putting it above your X & Y table

[@SeabassEngineering]

Thanks for the suggestion, I will keep this in mind.

[@managerlmw5382]

Nice work. Loving this series. Best use of a drill press I've ever seen. What's the make and model?

[@SeabassEngineering]

Thanks. It's a Meddings L2/B 3 Phase. I have it running on a Mitsubishi VFD on a single phase supply in the slowest belt speed. The VFD then allows me to go as low as 200rpm. I have sent a 1" diameter drill through a 1" thick steel plate with this machine in the past.

[@managerlmw5382]

@@SeabassEngineering Thanks. Giving me some ideas.

[@marccoogan6190]

Looks awesome! Could you tell me the size and where you purchased the enclosure? Keep up the good work!

[@SeabassEngineering]

The electronics enclosure was from eBay and the internal dimensions are approx 530x450mm.

[@jaimeandrade9973]

Amigo nos tiene como a novia de pueblo. Vestidos y alborotados. Cuando regresa con el part 9

[@mrmakinist]

where is the part 9

[@SeabassEngineering]

Should be coming in a few more days :-)

[@melissastevenson6673]

Nice dog Seabass

[@SeabassEngineering]

You should see my iguana