DIY Filament Extruder 5kg/h

[@jeremydasilvaloureiro7274]

hey how big should the hole of the nozzle be thank you in advance

[@about3d239]

Hello Jeremy, the hole is designed for our M30 fine thread nozzles.

[@jeremydasilvaloureiro7274]

how big is the hole of the nozzle

[@about3d239]

Hello Jeremy, this depends on the Filament which you want to extrude, because each filament acts differently.

[@jeremydasilvaloureiro7274]

I want to use pla filament how many millimeters should the hole of the nozzle have

[@about3d239]

I'm sorry, but there is not one size for PLA nozzle. It depends on your extruder screw, the pressure and so on.

[@MohamedMusthafamech]

Hi. I would like to know, what is the maximum operating RPM of extruder screw..!

[@Werbewunder]

Max RMP = 60-70 Working 15-30 RMP je nach Material

[@calleblomquist]

so ein High Tech Aufbau, aber keinen Gimbal oder gute Cam zum Filmen genommen. Das gewackel macht den Film ungenießbar.

[@lennybruder2153]

Das Video ist aber nicht von dir!?

[@about3d239]

Das Video zeigt einen unserer Extruder.

[@th33xitus]

@@about3d239 Das Video zeigt den Extruder vom Kanal +Werbewunder.

[@MrFaiqueShakil]

I hope all the materials can be extruded included PEEK Polymers from It. If don't what's thee point of so much complicated extruder.

[@Werbewunder]

You can extrude anything that melts up to 40 degrees Celsius. If you use a different barrel and screw, you can extrude up to over 500 degrees.

[@alparslangazimemis]

Hello do you have any idea what kind of heater i should use?