Making my own EN-49761 valve stem seal installer tool for Duramax LML.
Пікірлер: 10
@592_dmax8 Жыл бұрын
Dude, that's supper cool 🤘🏾
@johndacey3648 Жыл бұрын
What valve spring compressor did you use?
@TechnicianRed Жыл бұрын
Check my shorts. I took a video of it being used on this exact engine.
@tomcrossont8604 ай бұрын
Is this something that can be done in the truck? I made this mistake rebuilding the heads and was wondering if it’s easier than pulling the heads off again.
@TechnicianRed4 ай бұрын
Yes, I would recommend pulling the cab but leaving the heads on.
@THORRACING12 ай бұрын
Did you just put each one to tdc or pressurize cylinder
@THORRACING12 ай бұрын
Is this same for lbz?
@TechnicianRed2 ай бұрын
Not sure. Just compare the tool part # in the service manual for your LBZ to the part # I have listed in the video to see if they are the same.
@THORRACING12 ай бұрын
@@TechnicianRed ok thank you and did your drill the holes or use a endmill
@TechnicianRed2 ай бұрын
@@THORRACING1I drilled the holes in a lathe so they would be perfectly centered. The 7/16" and "J" hole can be drilled with a normal drill bit. The 9/16" hole MUST be drilled with an end mill to produce a nice flat surface to drive the seal.