Рет қаралды 353,322
Installation Instructions below:
1. Soak new Filter in water for 15 minutes prior to installing it in your refrigerator to remove air from the carbon block.
2. Grab Paper Towels or a towel, place in fridge under filter knob.
3. Twist the old filter counter-clockwise to unlock (lefty loosey)
4. Pull old filter straight out and discard.
5. Grab new pre soaked filter, water will still be in new filter, will be caught with towel in fridge if it spills out.
6. Insert new filter twist clockwise until locked (righty tighty)
7. Wipe away water that came out
8. Purge system by running two to three gallons of water through your refrigerator’s water dispenser to remove air and loose carbon pieces. The refrigerators water may be cloudy and may sputter until the air is removed.
9. Open fridge door and check for any possible leaks.
10. Reset your “change filter” indicator by pressing the Alarm/Filter Reset button by holding is down for 3 seconds. The water filter indicator should turn off.
If you wish to just turn the Filter Alarm Off simply hold the Alarm Filter Reset button for 3 seconds and it should turn off.