DIY Laser Engraver Fume Extractor

Hello friends
This project is a filter project that absorbs the smoke generated in laser engravers. Thanks to the carbon and hepa filters inside, it eliminates both smoke and odor. Below is all the information for this project that you can do at home.
Link for STL files:
www.thingivers...
Materials
Activated Carbon Filter : alishort.com/g...
Hepa Filter : alishort.com/s...
Strip Led: alishort.com/x...
LM2596 : alishort.com/D...
On/off switch : alishort.com/v...
24V/1A Adapter : alishort.com/4...
This filter was designed by myself out of necessity as I am a laser engraver user.
The design includes two impellers connected to a twin shaft hair dryer motor that sucks in the fumes. These impellers provide a strong air draft thanks to the 24 volt motor. The sucked air is first filtered through a carbon filter and then through a hepa filter. Then clean air is supplied to the outside.

[@gsbox2709]

Check out video next : kzbin.info/www/bejne/l6Kqk4qMq9p8mrM

[@knauerkustom]

thanks for the video. but: silly music in videos explaining something sucks.