DIY Stepping Stones using Cement All

How about a perfect addition to your home's curb appeal or outside landscaping? Get ready to easily 'Step' into this fun concrete DIY project! Rapid Set Cement All makes this project so simple. You can complete this in as little as ONE HOUR! To plan your Cement All stepping stones project today, here is a list of materials needed and steps to take.
SUPPLIES:
1. 4 parts Cement All
2. 1 part clean water
3. Stepping stone concrete mold (your choice)
4. FLOW Control packet
5. Pam spray
6. Concrete sealer
7. Spray bottle (for curing)
8. Protection goggles
9. Plastic gloves
10. Mixing supplies
ASSEMBLY:
1. Clean mold thoroughly
2. Spray mold with Pam
3. Add Cement All into the water and mix until peanut butter consistency.
4. Then add FLOW Control and mix until pancake batter consistency.
5. Pour into mold
6. Tap sides to remove air bubbles
7. Spray water lightly over the concrete stepping stone every 15 mins.
8. Allow the stepping stone to harden for one hour, then remove from the mold.
9. Seal your stepping stone once hardened.
www.ctscement.com
Contact us for more information at [e-mail]
OR 800-929-3030.