DIY Woodmizer LT15 power feed finished

[@nikkijeffers7533]

🤓💪 So happy for ya!! Loved seeing your animals too 😄

[@307j.o.a.t9]

Thank you!

[@aldredske6197]

Hi Travis!!😀😀 Glad you got it to work. I wonder if you could have just put a jumper wire in the plug where the second motor plugs in to trick the controller. Take care buddy!!😀😀💚 Logger Al

[@307j.o.a.t9]

Yea it works good. Im not sure about a jumper. Maybe if i cut the plug and wired a resistor in. Thanks for commenting!!

[@southernadirondackoutdoors]

I was thinking the same about a jumper wire.

[@307j.o.a.t9]

It may have worked. Not sure what the computer needs to know about that circut. I may see what the resistance is on that motor amd try it.

[@TheBeardedCarpenter]

Howdy Brother Travis- glad you got it all figured out. Hope all is well. Merry Christmas to you and your family. God bless

[@307j.o.a.t9]

Yea its awesome! I enjoy doin stuff like that. Now to mill some stuff. Merry Christmas!!! We are doin good!! Hope youre all well!!

[@andrewscott2866]

Good job! You have made me curious how that two motor setup works🤔 I live for projects like this!👍👍👊

[@307j.o.a.t9]

Thanks! I will get a little millimg done soon. It was a fun project! STAY SAFE!!

[@geraldminko4659]

Amazon sells a 12 to 24 volt converter for cheap...thats what i have on my mill. It works fine just make sure you get the higher amp rated one..

[@307j.o.a.t9]

Good to know! I didnt even think about looking for something like that. I was trying to finish without buying more stuff and needed to get it done without waiting for more parts. I will definently keep that in mind though in case this system fails in some way. STAY SAFE!!

[@geraldminko4659]

@307j.o.a.t9 yeah I even bought the mikron setworks for mine..

[@307j.o.a.t9]

@@geraldminko4659 oh nice!!

[@michaelwhiteoldtimer7648]

Glad it’s working, time to mill some lumber

[@307j.o.a.t9]

Me too! Heck yea!! I will have a video of it working soon. Thanks for stoppin by!!

[@justingray6703]

Good job! Did you use the right hand motor or the left hand motor to drive the mill?

[@307j.o.a.t9]

I dont remember exactly. Id have to go back and watch the video.