DJI FPV SYSTEM CONTROLLER, A LOOK INSIDE

[@escobarfpv1275]

I like it better than my Taranis and I damn sure don’t miss soldering up receivers, binding, setting up models and all that other crap.

[@imranpaxton6538]

i realize I am pretty off topic but do anybody know of a good site to stream newly released movies online?

[@imranpaxton6538]

@Milo Quinn thanks, signed up and it seems to work =) I really appreciate it !

[@miloquinn2867]

@Imran Paxton you are welcome :)

[@phildawe7172]

very helpful ! cheers

[@damianoficca1177]

What screwdriver do you use for this?

[@MaximumInertia]

How do you get your throttle up/down stick to stay in the position you leave it?

[@newcombnt]

For the life of me I can't find this and all the results are for the V2 controller. Tried loosening/tightening all the relevant screws, no dice.

[@MaximumInertia]

@@newcombnt I had to exchange mine with DJI for a diffent mode controller. According to the technician I spoke with, this feature is not available for Mode 1 and I had to switch to a Mode 2 remote. DJI support was very understanding and exchanged my remote in less than a week!

[@newcombnt]

@@MaximumInertia Just this morning I actually took it apart (with help from this video); was hoping not to because... as he shows, gotta put a lot of force and I'd probably break it (didn't though). I have the throttle tension spring and screws in Mode 2 just like this guy. Before I took the back off, it felt like the tension screws were all the way down, but when I got it off I saw there was a lot more slack on the screws. So I cranked the screws all the way down, which took some elbow grease, and now the throttle stays in place! Then I just backed them off until I got the right "give", and I'm all good.

[@MaximumInertia]

@@newcombnt I'm glad you were able to get it to work! Wish I had done the same, I preferred the other mode much more. Best of luck with your future endeavors!!

[@martinpantoja5373]

It didn't show nothing about the throtle stick in position .hey mate it was easy to take off apart is that all you know ?...

[@andrewmoore193]

Do you repair them

[@JustShootLight]

I’ve been contemplating a project: do you think it would be possible to fit the internals into a controller shaped like the tbs tango or the jumper T-Lite?

[@gus8378]

I'm sure it would be possible

[@marcossemenzato3298]

Thanks for the video, it is very well explained. I would like to ask you if you know how to return the control to factory values, I am experiencing a problem that I cannot solve. Although the radio works in its calibration and as a control to move in the glasses menu, it does not work for me to pilot my drone. It occurs to me that perhaps restarting the radio and re-binding it could be solved. Thank you very much

[@RollnHeavyKevy]

You might have the controller set to the low latency mode and the drone set to the standard protocol. Try switching the controllers latency mode. I think they call it suspicious fast. You probably have it figured out by now, just wanted to lend a hand.

[@marcolomiller]

why the hell they dont make it easy to open. moder foquers