Dremel Flex Shaft First Look and Demo: Great tool for woodworkers!

Рет қаралды 3,300

Күн бұрын

Пікірлер: 13

@anthonycasilli6747 5 ай бұрын

I hang mine from the basement ceiling and like it a lot. My Dremel has a hook that i put thru the hole in my spring clamp and i hang it from a cross board. Makes it super easy to move around if i want to go else ware or just take it down. They also sell a hook for your bench but it was flimsy...

@HomestyleWoodCrafts 5 ай бұрын

Great tip. Thanks for sharing!

@FuzzyLiger Ай бұрын

Same, I find hanging it makes it much less on off siding the weight.

@SunnyDarkoShow 19 күн бұрын

Will the shaft still cut through metal with say a seperating disk to silver, really need your help here x

@HomestyleWoodCrafts 12 күн бұрын

I haven't tried that. I would check the owners manual if you have it or the dremelwebsite. They might have a chat feature for customer support.

@cosmicfxx 5 ай бұрын

Yeah I see most folks hang the main dremel above, it also is apparently good for the flex shaft as there's less wear n tear

@HomestyleWoodCrafts 3 ай бұрын

I am planning on building a small stand to hand the main Dremel unit on in hopes that it will take the weight of the unit and shaft.

@paulpardee 5 ай бұрын

I had similar problems with the flex shaft. It always seemed to either be too loose or too tight. And then the inner drive fell out and got covered in gunk (because it's coated in grease) and I just got fed up and picked up a vevor flex shaft grinder. They're dirt cheap, much quieter, much more flexible, has a speed control pedal and it's a fixed shaft, so it's not going to fall off or get tight... the only downside is the chuck key is a non-standard size. You lose it and you're pretty much toast. That said, you're doing better work with the dremel than I am with my vevor :D

@HomestyleWoodCrafts 3 ай бұрын

Thanks for sharing your experience. I am hoping I can get the dremel set up so its a snap to use.