drilling rig shell & auger

[@chiccy2112]

I love how we all have the spt rods out like we use them.... they're always clean lol

[@amg8868]

chiccy2112 yellow hat should have been rubbing the spt with a bit of fresh clay... bet that trip hammer is siezed up lol

[@jiperez190169]

Old cable drilling system. my question are as follows: is casing drilling with cable?, you don't has stick?, how many meters are drilling?

[@GakuruMacharia]

how much would you charge to build one? i need one to take to Africa.

[@DandoDrilling]

Good work, lads.

[@127069]

bet you wish you could say to the hacks that work in your factory good work

[@julioxavier8762]

como adquirir uma maquina dessas

[@davidbrowndrilling]

@manstock2 I have 2 videos of rig setups. I do the same type of drilling as this. Good work lads.

[@benceluzsinszky]

this will be my favourite song :D

[@RF-yh3qh]

how deep it really can go? Whats the limitation for it? I mean can it reach 130m?

[@ruthlessjun2713]

+Ricardo Fabar no u cant,this rig is for shallow borehole,usually used for soil investigation.

[@amg8868]

Ricardo Fabar i am a driller from kent, UK... I drill using one of these rigs, i am experienced and the deepest i have drilled is 96 metres open hole 150mm diameter in chalk. i couldnt go any deeper because i physically couldnt fit any more rope on the drum, the stretch on a 13mm rope at this depth is a bit too much too...

[@RF-yh3qh]

Thanks Gary!! that's pretty good! more than enought for such small cable rig! I'm building one.....

[@amg8868]

Ricardo Fabar how you getting on with that? what engine you using? dry or wet clutch?

[@RF-yh3qh]

Gary, I got the winch ready with a 5cv electric motor, dry clutch.... but I'm planning to switch to a diesel engine. Not sure if I could try a small petrol 10hp engine, because all I have seen are bigger stationary diesel engine with large flywheel on it, so probably I will need that for momentum. How much power did you have on your engine 12hp or 25hp?