Dropping the Fuel Tank and Installing Fore Innovations Triple Pump Fuel Hat on the SVT Lightning!

[@hdcircuitry]

Great vid....looking forward to part 2 with the wiring install! lol

[@DebtLife_Projects]

Editing that as we speak lol 🤘😁

[@hyslopboys9600]

The video I’ve been searching for, thank you!

[@DebtLife_Projects]

No problem, got a bunch more fuel system videos comin! 🤘😁

[@pemoramirez1037]

Been waiting on this video.

[@DebtLife_Projects]

Bunch more incoming! Full fuel system turned out awesome 🤘

[@tiburcioislas9567]

Nice I just had the same fuel system installed on my L

[@DebtLife_Projects]

Nice! It's a nice unit, that's for sure.

[@605BOLT]

That hat is a nice piece.

[@MatthewMuhlenkamp-zi7ye]

Appreciate your all videos and content! Helped a lot on my white 03 restoration journey. I’ll be dropping my fuel tank today. Interested in evap delete process as well! You still planning on make a video to cover?

[@albertooropeza2505]

Did you ever do a video on the gas tank venting

[@DebtLife_Projects]

I didn't, I was advised not to, due to epa cracking down on that kinda stuff, not worth the risk. But it's easy, just run a hose off each vent on the tank, to a T fitting, then one hose up the filler neck to a breather filter. I also packed my breather filter with fish tank charcoal, to help with the fuel smell.

[@3500camarz]

Hopefully your fuel sending unit still sends an accurate reading to the fuel gauge. Also, is there a reason you used crimp connectors instead of soldering and heat shrink?

[@Fastcarsticklemypickle]

Sweet! Fuel system stuff, that means it's getting close! Can't wait for this thing to fire up! 💪

[@BabyJake426]

I have a similar triple pump fuel system, from a different vendor, installed on my L. I did have an intermittent problem with my fuel quantity gauge reading zero. A local Ford dealership technician found that the triple pump and fuel quantity sensor had an interference fit. He fixed it and all is well. Just an FYI… Thank you for the great vids, DebtLife!!! 👍🏼😁

[@JB-zn1kx]

No way you would have known... but I bought that setup and then never needed/used it. Would have given it to you just to see it used. :(

[@DebtLife_Projects]

Dang, wish I knew that lol, this thing hurt the wallet lol 😂

[@02Lightning]

I’ve got a question that you might be able to help me with, when I get on it in my 02 lightning at full throttle right about 100-105mph I notice it cuts out just a little bit but nothing to bad. It has a 6 lbs lower and K&N cold air intake with a hand held SCT tuner. The MAF sensor seams too look stock.

[@DebtLife_Projects]

That can be a ton of things and impossible to know without more data/info. First thing I always do is start with the plugs. Pull, look at, and replace the plugs. I'd also be skeptical of a stock maf with that much pulley, needs a ba2600/retune, and also no boost cooling mods? If not, get some asap, these blowers create a lot of heat.

[@02Lightning]

@@DebtLife_Projects okay thank you so much for the info! I’ll be sure and do that!