Duplicolor Bed Armor Jeep Grille, Project Renegade Update

[@LJR_LIMITED]

This looks like it would be good for renewing the plastic around the offroad lights up top, too

[@Glendram]

Thank you for your Video about the Bed Armor, I have just sprayed the front grille and side mirrors on my Landcruiser 80 Series. It looks fantastic but i noticed how soft it was on a test piece after 2 days. I was a bit concerned but after seeing your video i fear no more. Thanks !...Glen, South Australia.

[@TheBeardedJeeper]

looks great man, can't wait to see how well it lasts

[@RockyXTV]

So far so good. I'm hoping it lasts because I'm just itching to paint a bunch of crap with this stuff!

[@ChadMyers73]

Looks good time to do some body accents with it...

[@RockyXTV]

I've been going nuts with this bed liner spray, I might end up with a totally bed lined Liberty LOL!

[@derekarndt5378]

Did u doing any prep work to the plastic

[@JoeyRock333]

Great Libby. Would you recommend doing the fender Flares?

[@atm-n4187]

Hi, what kind of grill bar is that? Where can l buy it? Thank you

[@jessemcdonald3688]

Have you done a Liberty heater core repair dash dismantling

[@RockyXTV]

I have yet to do that, key word "YET" The Liberty has 200K on it so it might be an upcoming repair. Sorry I couldn't be of any help right now though. Thanks for watching!

[@chopperhead2677]

Jesse McDonald hey bud I’ve had to do the notorious blend door repair on my 03 renegade and it simply SUCKS!! In total it took me the better part of a Saturday to dismantle, 10 minutes to replace the broken door and all Sunday to put back.

[@RogerJG21]

Man that looks nice , I like it better then stock. good job did you get the LED light Ring?

[@RockyXTV]

I completely forgot, I'll go check today.

[@gustavovalentin8953]

I love your job. Could you tell me where to get the manual to adapt the defense rough country ligth bar to my liberty 2004? greetings from Spain!

[@RockyXTV]

I'm honestly not sure. Have you tried Rough Country's Tech support?

[@gustavovalentin8953]

@@RockyXTV thanks man!

[@chopperhead2677]

I’m holding your front fascia hostage, if you ever want to see it again leave a pizza on the corner of First & Main and remember don’t call the cops or the fascia gets it. Lol

[@RockyXTV]

I'll bring the pizza, just don't hurt the FASCIA!!!

[@chopperhead2677]

Too funny. Hey Rocky great vid again. Keep me coming man we appreciate them and you for doing them.

[@patriotbiker2594]

Any updates?

[@cliffordjohnson943]

Roughly how much power is your liberty making with the bolt-ons and chip?

[@RockyXTV]

The Chrysler "PowerTech" 3.7 put out 210HP stock. With the added cat-back exhaust, headers, intake, spacer, chip all added together as a package... I'd say around 235-245HP on 93 octane gas. Others that have rode in it say it feels like more than that, but I'm being conservative I guess. This would definitely be a bigger number if I had a better tune on the computer rather than the preset chip tune. Thanks for watching!

[@ericraeder9995]

What's the wheel and tire combo I like that a lot and want that for my 05 renegade

[@RockyXTV]

The wheels are U.S Wheel Crawler with beadlock, and the tires are Interco Super Swamper IROK NK.

[@ericraeder9995]

@@RockyXTV Thanks how much did it caust for all four of them

[@RockyXTV]

The 5 wheels and 5 tires were Promo/Sponsor products from Interco Tire and U.S Wheel, so I don't know what the cost would be. I did forget to mention that the wheels have a custom offset, they built these wheels just for this project. You can get the same wheels that will fit, but they will stick out just a little bit. You can check out the video about the wheels and tires here - kzbin.info/www/bejne/jGbInaKgi69geaM

[@ericraeder9995]

@@RockyXTV Ok thanks for the information

[@MegaOldschoold]

Was looking into plasti dip as the front bumper on my 05 renegade is very faded. I wonder if this would be better??

[@RockyXTV]

This would be better as a permanent solution where as Plasti-Dip would be temporary. I personally don't use Plasti-Dip as it's not permanent, you can just peel it back off. This is okay if you are just wanting to know what something would look like as a certain color, but not to actually paint or refinish something permanently. This Bed Armour will be a lot more durable than Plasti-Dip as well, this stuff is an actual coating that when applied correctly yields a very tough finish. I'm not bashing Plasti-Dip, I've just never had a real use for it. Thanks for watching!

[@ericraeder9995]

I used plasty dip on my bumper and and fender and grill and so far it seems to be hloding up good.

[@jakeri939]

You know how some Liberties came with two-tone? My 06 Limited didn't come like that, so I used plastidip and did it myself. Holding up fine, looks pretty good. I'd recommend it, but you'll have to touch up on it every few months. Try not to overspray

[@glennhinatsu1110]

Hello. I have a 2007 jeep liberty limited. Would you happen to know why my ABS,Traction control light and BAS/ESP lights came on together. I also lost use of my cruise control button on the steering wheel. Are all these related? Could it be a wire or the "clocking spring" behind the steering wheel?

[@RockyXTV]

This could be your clock spring, but it also sounds like an ABS wire issue. If there is an issue with ABS the vehicle will disable cruise control. I do not have ABS on mt KJ so I can't say for sure, but I would start simple by checking fuses and ABS wires at the wheels. Thanks for watching!

[@ahmadjabali6446]

Can you give me the dimention of the grill cuz i wanna buy one and to fit it on another car

[@TwoFavoriteRednecks]

What lift kit did you use for this? I have an 05 Liberty I want to lift but can’t find any for the Renegade trim. She looks awesome!

[@RockyXTV]

Thanks! To answer your question about what kind of lift... A bad one! It was a 2.5" inch kit from Blitz Auto on Ebay. It has destroyed the entire front suspension in less than 10K miles! The rear is still fine, but I would definitely nor recommend that kit. The front end is only about an inch over stock now... Thanks for watching!