Duravent's PelletVent® Multi-Fuel Venting Kit

[@jeffreyallen3777]

Tees, elbows, 45s all leak smoke and ash because typically they are not properly factory sealed on the inside where joint sections are connected. This is a very common complaint and although the outside of the connectors can be sealed with hi-temp silicone or tape this should not be necessary. The twist lock joints work great.

[@AugeredInn]

I hate the way there is no details on the appliance adapter. How much silicone, where do you put the silicone, what kind of silicone, how far does the adapter need to go onto the stove, does it need screw to stay in place, how long before the silicone is ready, do all pipe connections need silicone if they are located indoors. I tried calling Dura Vent, no one available. They said to leave a message and phone number and they would call back. They never did.

[@weinfb10]

MY specific pellet stove allows a straight shot out of the building in the installation instructions. i am also forced to do this because it must sit on a raised structure based on my local code. this doesnt leave me with enough rise before i get too close to the soffits. if i do a horizontal termination, do i still need a Tee cleanout inside before terminating outside the building?

[@mongoTheIdahoGuy]

Great video, my kit box only came with instructions in French (I'm guessing). That was kinda sucky.

[@christopherbodden506]

Do i need an extrap piece to get it out the wall in a corner? One 12” length wont do it

[@thefitzwater4805]

This Old House showed me a direct straight out of the wall vent is A-ok.....

[@jamescole3152]

Unless the power goes out.

[@wildwoodtop]

Do you need a wall Thimble if you're going through concrete block wall with pellet stove exhaust 🤔

[@DuraventGroup]

Great question! The answer is yes! Check out this video short for a little more info from our retail team! facebook.com/DuraventGroup/videos/1416080152588255

[@wildwoodtop]

@@DuraventGroup Would a metal sleeve act as a thimble through a block wall 🤔

[@paulmarino8810]

Can the T go on the inside of the house?

[@nataliebradley2923]

I have the basic installation but the height is pretty low and the smoke blows outside my window, essentially seeping fumes back into the house. Is it safe to add an extender pipe, like the the 36" straight length pipe?

[@jamescole3152]

Of course.

[@hogo118]

Everything works as it should except for the clean-out cap. It leaks a lot of smoke through the bottom of the cap into the house on startup. (Interior "T" with the pipe going up to an elbow and out.) Then, when the draft is created and the stove is running, the smoke stops leaking at the cap. It appears that the seal/caulk in the cap may be faulty?? Any suggestions are appreciated.

[@natekelly9729]

The t goes outside the house its in the video and on the box

[@jamescole3152]

the room echo is horrible.

[@randykelly8302]

So what can you cover this ugly pipe on the side of your house...this can't be the finished look...

[@boyddecker3120]

I always paint mine with a black high-heat grill paint.