Here I replace the power supply capacitor can in a Dynaco PAS3X, as well as a few signal caps that may help improve sound quality. The overall result being positive, with an improvement in sound clarity and low end definition.
Пікірлер: 9
@jackstanley35294 ай бұрын
Crosstalk seems to be a common issue with the PASs. I was recently asked to see if I could remedy this on a friend's PAS that I had serviced. I found two things: 1) leads from different inputs are tightly run in parallel together to the selector switch. This looks tidy but causes signal from one input to be induced into the other. Re running these individual wires randomly (it can be done neatly) did help but not completely. 2) The grounds for line level inputs are lifted by a 10 ohm resistor at the inputs. So, although the selector switch shorts the unselected inputs to ground, the 'shorted' inputs are seeing 10 ohms. This will effectivley short high impedance input devices but on something like a cathode follower output with low impedance, it will happily drive signal into a 10 ohm load. Shorting these ground-lift 10 ohm resistors in conjunction with 1) will pretty much take care of the crosstalk. Still, for critcial listening it is best to shut off inputs not being listened to.
@campbellmorrison8540 Жыл бұрын
Excellent. I'm 69 now and used to love my stereo but now I wouldn't know a good one from bad. Enjoy your ears ( yours are obviously pretty good ) while you can. Great to see somebody maintaining old kit.
@jothanankrogh Жыл бұрын
Thank you, I seem to be only interested in equipment from the distant past in the tube era!
@ekbanjosworld4926 Жыл бұрын
Tubes will sound a bit slower. Maybe you're use to the Solid State sound ? It is definitely quicker, faster with more solid thump ?
@QAudio8 ай бұрын
Do you have the list for the parts to buy?
@moodyga40 Жыл бұрын
all the black coupling caps will be leaking
@ekbanjosworld4926 Жыл бұрын
Damn ! Do you have a hamster or gerbil running on a metal wheel or what ? What's the terrible squeeking noise ?
@moodyga40 Жыл бұрын
i would put the tube rectifier back the voltage will be to high