this is best video to explain the turning moment ....thank u
@michaelthomasrex2 жыл бұрын
Thanks for the comments
@Gokhulkumarkashyap0110 ай бұрын
Thank you sir
@michaelthomasrex10 ай бұрын
Keep watching. Kindly subscribe to the channel 🙂
@zheko78972 жыл бұрын
this was very helpful
@michaelthomasrex2 жыл бұрын
Thanks for the comment. Kindly subscribe the channel for more updates.
@odysseyhopkin4145 Жыл бұрын
I think you used the wrong tmax value when finding fluctuation of energy, the slide before it was 13751 but after it was 13571
@michaelthomasrex Жыл бұрын
Yes. sir, it is a typo error, you can solve it by substituting it by 13751. Thanks for informing.
@adityasrivastava40633 жыл бұрын
Nice
@michaelthomasrex3 жыл бұрын
Thanks for your comments. Kindly subscribe to the channel and watch the lectures.
@NAGUMURALA Жыл бұрын
Sir I didn't understand why theeta is only pi/2 in tmax
@michaelthomasrex Жыл бұрын
The maximum torque is obtained at exactly middle of the power stroke. Hence the angle is pi/2. The total angle covered during the power stroke is pi.
@selvakumarg8484 жыл бұрын
Good
@michaelthomasrex2 жыл бұрын
Thanks for the comments 🙂
@beemishettyvamshi47932 жыл бұрын
how to know that 3 strokes are blow thwe line
@michaelthomasrex2 жыл бұрын
The positive work is produced in the engine during the power stroke (expansion) only. The remaining three strokes use the existing available energy to complete the cycle. Hence, the suction, compression, and exhaust areas are represented below the line.
@mbalenhlembina3732 жыл бұрын
@@michaelthomasrex But how do we know that the positive work is produced only during the power stroke, I've seen some turning moment diagrams where the suction stroke produced positive work