E1 Electronic Running Board Installation Ford Bronco

[@sroessner]

Good video it would be great for you to do a second video just for the 2 door. It is significantly different. A few things to note. 1. The controller is different and mounts directly behind the drivers rear motor. This means that you need to install the controller before you install the read motor. Second, there is really no way to ground the door sensor to the seat belt without taking all the molding out (which is a huge pain in the 2 door). Instead you can ground it to the drivers chair. Speaking of chairs, you really need to remove the drivers and passengers chair completely in order to fish the passenger wire across the car. It's still a pain but can be done. Lastly you will have a MUCH easier time tightening the four motors once everything is installed and the steps are deployed. With that said, all the work was totally worth it.

[@jlpotter68]

can you show how you mounted behind the rear motor. I see no mounting holes for brace :(

[@sroessner]

@@jlpotter68 Sorry, I didn't see this comment until right now. I'm assuming that you figured it out but the literally on the frame rail directly across from where you mount the rear motor.

[@JDMSiR9]

​@@jlpotter68they shipped a u snapped bracket and it goes through the frame on the driver's side inside two holes. Use supplies plastic washers to hold in place and install module and washers and nuts

[@agredneck]

I have a jeep wrangler and no matter what i cant get my door sensors to work! What do you think can be happening?