"EASY DIY: How I Replaced The Power Steering Hose On My Honda Odyssey!"

[@diymanual]

👍 If you found these DIY tips helpful, make sure to smash that "LIKE" button and "SUBSCRIBE" for a steady stream of DIY knowledge! Stay empowered to tackle any project around your home, car, technology, or pool with confidence. Let's get hands-on and make life easier together! 🏡🚗🏊‍♂ #DIYLife #SubscribeForMoreDIYTips

[@davidsutherland6224]

You’re the first person I’ve seen that had the idea of worrying the pipe off the bottom bolt. That makes a ton of sense and has to make it so much easier.

[@diymanual]

Thank you so much for your kind words! I'm glad you found my idea helpful. It's always great to hear that my tips and tricks make a difference for fellow DIY enthusiasts like you.

[@hypefxx9011]

Best video so far with great camera angles in the engine. Good job

[@diymanual]

Thank you so much for the kind words! I'm glad you enjoyed the video.

[@MrBillybathgate5]

Thanks brother …. Just did this job yesterday …. It’s super easy with a flare nut crows foots 14

[@diymanual]

That's awesome to hear! Glad it went smoothly for you.

[@Elniniss]

You can use a ratcheting flare nut wrench. It makes it way easier.

[@diymanual]

Thank you so much for sharing this tip! I always appreciate learning new tools and techniques that can make my work easier. Can't wait to try it out!

[@jbfontz2898]

Nice pressure hose removal 😊

[@diymanual]

Easy way to do it since it will be replaced anyway.

[@stevenshi8461]

Great video, very detailed. Thanks!

[@diymanual]

Thank You.

[@solkinar]

Every video shows someone using a crowfoot wrench for the bottom flare nut. Not sure why as I used an open ended wrench from up top.

[@diymanual]

@@solkinar The nut is very tight at the bottom plus the awkward position can cause the wrench to slip.

[@solkinar]

I sprayed it with liquid wrench. Let sit for 10 mins. Used my 9/16 open end wrench because it's longer than my 14mm. Able to get squarely on the flare nut. No slippage, no busted knuckles. Maybe it helps that I've been turning wrenches for over 30 years but this job is fairly basic.

[@diymanual]

@@solkinar Cool. Thanks for sharing your technique.