*EASY* Ford F-250 wheel stud replacement

In this video I replace two bad wheel studs without removing the axle or the emergency brake shoes. The wheel studs and lug nuts are M14x1.5 .

[@kevokell1]

Thanks for the Vid! Tips saved me about 20 mins out here in 90 degree garage

[@Horsemanism]

Fantastic Video I loved it thank you for posting it and keep up the good work

[@claudioclaudio9678]

Very clear video, thank you so much for posting,

[@sebastiancortes2118]

Thanks a ton! I did the same mistake trying to get some wheels on

[@robinkelley8124]

Great Video SmokeyJA

[@timothysummers671]

I was wondering how to get those in.

[@davidhernandez-serr7875]

Thx! Dude I had 2 wheel studs broken and I was really scared my wheel was going to give out on me

[@SmokeyJa]

David Hernandez-Serr glad it helped!

[@HHI455]

why are you touching the pads with grease?

[@rickbarkman9062]

Good video thanks for the help

[@SmokeyJa]

Thank you for the comment. It makes it worth it knowing it helped. I’m about to do a complete brake swap video in the next few weeks.

[@johnkru7400]

Thanks

[@rc9660]

Thanks, My question is: I see the jack stand, did you need to put another jack stand on the other wheel too? The whole rear end up? And what about turning the wheel every time I need to get to that spot to change a stud out out? Does the truck need to be in neutral, rear end up, front wheels chocked to rotate the wheel to the sweet spot? How did you change one up there, yet change the other down there? Hoe did you rotate your wheel to the sweet spot? That is my question. Thanks

[@HHI455]

Just put it in neutral and turn the hub.

[@justinwoolfrey2772]

Is there a torque setting for the nuts on the caliber?

[@SmokeyJa]

There is but I do not remember it off the top of my head. I torqued them after the video. I have sense replaced all of the brake calipers on the truck with SSBC.

[@richardpetty4960]

Is a 2003 F250 the same??

[@bluntsmokerbx]

Would this work for a 2008 econoline van?

[@SmokeyJa]

bluntsmokerbx I would assume so. Is it a 250/350? If so it should have the same parts

[@bluntsmokerbx]

A e350

[@IDIturboDiesel]

The Ford E350 van uses SAE lug studs.

[@jaimecornejo2185]

What about the front ones? Is it the same or is axle removal necessary?

[@SmokeyJa]

Jaime Cornejo front should be the same. I can’t remember if I had to do the front as well but the front is disc brake as well. I really can’t image the axle would have to be taken out for the front.

[@jaimecornejo2185]

SmokeyJA thank you sir I appreciate it.