Should have taken the muffler off and give it a good rinse on the inside. One metal shaving getting into the cylinder can be enough to screw it up.
@jakeharris44652 жыл бұрын
The only reason your cylinder didn’t fill up with metal shavings is because you didn’t drill through the centre wall of the muffler,if you take the muffler off then drill through second wall also it will perform way better than just drilling outer hole
@josephholman17132 жыл бұрын
To who ever that may watch this take the muffler off the saw before modding it all it takes to ruin the piston an cylinder is one metal shaving as the saw runs it will pull any shavings that are in the muffler inside the cylinder
@jbbolts2 жыл бұрын
i bought a running 026 with 2 muffler screws that had come loose in the muffler rattling around lol.... it was idling super high ...basically running instead of idling... got it home played with the screws on the carb and installed the muffler screws and got it running like new. I had no understanding of how carbes even worked at the time. dumb luck. all that to say the screws never made it into the engine
@landybob83932 жыл бұрын
Do you have to adjust carb after doing a muffler mod?
@slimmers003 жыл бұрын
Thanks for the videos. Do you happen to remember what size bit you used for the final diameter?
@aha25512 жыл бұрын
Thanks for the video, it would have been good to see the saw running before & after the exhaust mod....but that's another whole load of video-ing! :)
@landybob83932 жыл бұрын
Do you need to adjust carb after doing this mod
@GlockPointer3 жыл бұрын
Thank you, excellent saw
@הראלרמז2 жыл бұрын
I have a cs2511t saw and I want an exhaust like you did with two pipes Where can I buy such an exhaust?
@D0praise2 жыл бұрын
been a few months since you posted. Have an update for us? How'd it go?