News flash I had bought a new carburetor for a Echo PB250 LN BLOWER - well the coil went bad which would cost the customer $75.00 - didn't get fixed with that price . So I got this HC-150 Echo hedge trimmer in from the same customer that the PB250 Carburetor interchange with and all went well -all I had to do was switch the throttle linkage mechanism. Now it's the same customer that had the Echo blower ,now he gets to enjoy some. Of his old-new parts off his blower on his hedge trimmer. End of a good story ..... Again thanks for the informative video ...
@chrisradano4 жыл бұрын
My HC 150 is 16 years old, and I just replaced the carburetor. I started using the premixed ethanol free fuel about 3 years ago. Ethanol will literally kill your power tool, I have a feeling my small engines will last much longer from using Trufuel. The fuel tank grommet is a real pain, years ago I had one disintegrate on me and soaked my leg with fuel. I think the aftermarket grommets are harder material, and more difficult to push into place. I pulled out 2 lines and finally got it in, after using a drop of dish soap. I suppose the 2 gaskets can go in either direction, I lost track how one of them went. But I started my HC 150 right up, runs brand new. Thanks.
@marshallborder90895 жыл бұрын
Thanks : getting ready too replace a carburetor on a HC150 - big help .Going to save video for the event coming ! 👍
@foghornleghorn41977 жыл бұрын
Thank you. You edited out problems we're going to run into - like getting the fuel grommet back into the gas tank, putting the throttle cable back, and finding & adjusting the idle screws. Because of video length?
@andrewbratos69074 жыл бұрын
i love them trimmers, i got 4 of them,2running 2gonna be
@yoboi57755 жыл бұрын
Can you do seafoam on this one too
@FernandoRodriguez-ds5ri3 жыл бұрын
What’s the air filter and air filter cover and wing nut part numbers? I have same hedger. Great video btw
@TheJrak478 жыл бұрын
The idile still didn't sound right what do you think of the machine did it last very long for you before any problems and are they idurable enough you think?
@jasonvalleyag15203 жыл бұрын
Hello! I have a question. I have a HC 150 but my carburetor doesn’t look like that. I ordered a replacement carb for it and the replacement looks like yours. But the one I pulled off doesn’t. Would you mind taking a look at it
@MrJusjones01107 жыл бұрын
Hey you wouldn't happen to have the correct model number for the Hc150 hedgers' carburetor would you?
@robscottboise5 жыл бұрын
Every time this guy gets doing important part he stops the camera and skips it avoid this video
@43128lucky410 жыл бұрын
do you have a boatyard near you? you can get ethanol free gas from those places
@Akrowdya649 жыл бұрын
Was your throttle cable a bit too short? I just tried installing mine and it needs to be a quarter inch longer. I hope i can figure it out, I think it has something to do with that brass fitting.
@zombiedave65027 жыл бұрын
Turn the brass throttle link on the carb 180° . the cable actually goes up inside the throttle body linkage. If you have it wrong it will high idle because the throttle wont close.